Compaq V 55 Manuel d'utilisateur télécharger pdf (Page 5)

1-4 English

Writer: M. Silvetti Saved by: Marianne Silvetti Saved date: 06/24/98 4:36 PM

Pages: 14 Words: 2440 Template: c:\msoffice\templates\working\comm.dot

File Name BCH1_EN.doc Part Number 308012-001

Setting Up the

Monitor

To set up the monitor, ensure that the power is turned off to the

monitor, computer system, and other attached devices, then

follow these steps:

1. Place the monitor in a convenient, well-ventilated location

near your computer.

2. Connect the monitor signal cable 1 to the 15-pin connector

on the rear panel of the computer and tighten the screws.

✎

Be sure the signal cable aligns with the 15-pin connector. Do not

force the cable onto the connector or you may damage the signal

cable.

3. Connect the monitor power cord 2 to the rear panel of the

monitor, then plug the other end into an electrical outlet

that is easily accessible and close to the monitor.

WARNING:

To reduce the risk of electric shock or damage to your

equipment, do not disable the power cord grounding feature. This

equipment is designed to be connected to a grounded (earthed)

power outlet that is easily accessible to the operator. The grounding

plug is an important safety feature.

CAUTION:

Be sure that the power outlet you plug your power cord

into is easily accessible and located as close to the monitor as

possible. When you need to disconnect power to the equipment, be

sure to unplug the power cord from the power outlet.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Pas de commentaire

Compaq V 55 Manuel d'utilisateur Page 5