Compaq AMC20493-KT5 Guide de dépannage Page 112

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 149
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 111
Reference Information
Reference Guide 7–3
O
n
0=go online, 1=go online and initiate retrain sequence.
P Force pulse dialing.
Q
n
0=enable result codes to DTE (default), 1=disable.
S
n
Select S-register n as default.
S
n=v
Set default S-register n to value v.
T
Force DTMF dialing.
V
n
Report result codes: 0=short form (terse), 1=long form
(verbose) (default).
W0 Report DTE speed (default).
W1 Report line speed, error correction protocol, and DTE speed.
W2 Report DCE speed.
W3 Report DCE speed and error correction protocol.
X0 Report CONNECT result code on connecting. Dial tone and
busy detection not reported.
X1 Report CONNECT <text> result code on connecting. Dial tone
and busy detection not reported.
X2 Report CONNECT <text> result code on connecting. Dial tone
and busy detection not reported.
X3 Report CONNECT <text> result code on connecting. Dial tone
not reported, busy signal reported if detected.
X4 Report CONNECT <text> result code on connecting. Dial tone
and busy signal reported if detected (default).
Z Reset to default configuration.
+DR:
a
Select error control protocol: NONE=no data compression,
V42B=42 bis in both directions, ALT=MNP 5 compression.
+DR=
n
0=disables extended format “+DR:” intermediate result code,
1=enables.
Conexant AT Commands (Advanced Users Only)
(Continued)
Command (Conexant)
319954-001.book Page 3 Thursday, February 3, 2005 3:03 PM
Vue de la page 111
1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 148 149

Commentaires sur ces manuels

Pas de commentaire