Compaq 3200 Spécifications télécharger pdf (Page 29)

2-9

Compaq Smart Array 3200 Controller Reference Guide

Writer: Rickard Project: Compaq Smart Array 3200 Controller Reference Guide Comments: 340862-002

File Name: C-CH02.DOC Last Saved On: 12/7/98 8:33 AM

COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED

To move an array, make sure all required conditions are satisfied, then:

1. Power-down the system.

2. Move array (including all drives in the array).

3. Power-up the system. A 1727 POST message should indicate that logical

drives were added to the configuration. If a 1785 (Not Configured)

POST message is displayed, turn the system off immediately to avoid

data loss and return the drives to their original locations.

NOTE: If you move arrays from a dual-channel controller to a single-channel

controller, you may get an error message indicating a configuration error. If you

get this error message:

❏ Return to the previous dual-channel controller configuration.

❏ Back up data on the array.

❏ Move the drives to the single-channel controller.

❏ Run the Array Configuration Utility on the single-channel controller to

configure the array.

❏ Restore data to the array.

4. Run the Array Configuration Utility to view the new drive configuration

or to assign spare drives (optional).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 210 211

Pas de commentaire

Compaq 3200 Spécifications Page 29