Compaq MPAC-18 Manuel de service télécharger pdf (Page 10)

Page 10

MPAC-18 Manual

the computer, the computer is held level while the allen screws are installed through the bracket. Tighten

the allen screws to 20-25 ft/lbs.

Clearances:

Airflow: Inlets and outlets must have at least 1 inch (25mm) around them and not be obstructed for

adequate airflow to maintain the correct working temperature. In a military environment, the panel into

which the unit is mounted should provide protection from dust.

Cabling: All input/output (I/O) connections are via bottom access. At least 8 inches (20cm) of

unobstructed space is required at the bottom of the computer for unrestricted cable connection. See

figures 9 and 10 for bottom connector panel layout.

Brackets: See figures 3 and 4 for proper clearances for each bracket assembly. An access area of

approximately 4 inches (10 cm) to the sides is required in the area of the allen screws that mount the

computer to the bracket.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

Compaq MPAC-18 Manuel de service Page 10