Compaq T5720 - Thin Client Guide de l'utilisateur télécharger pdf (Page 15)

Hardware Reference Guide www.hp.com 2-3

Hardware upgrades

Removing and replacing the chassis cover

To install internal hardware, you must remove the chassis cover as

shown in the following procedures.

WARNING: Before removing the chassis cover, ensure that the thin

client is turned off and the power cord is disconnected from the electrical

outlet.

1. Remove the two screws that secure the cover to the chassis 1.

2. Slide the cover about 1/2-inch toward the back of the unit, and

then lift the cover off the chassis 2.

3. Disconnect the speaker cable 3 from the system board.

Removing the chassis cover and disconnecting the speaker

To replace the chassis cover, reverse the previous procedure.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Pas de commentaire

Compaq T5720 - Thin Client Guide de l'utilisateur Page 15