Compaq AlphaServer 160 Guide de l'utilisateur télécharger pdf (Page 129)

Operation 7-19

➊

The total system memory size is reported.

➋

Each memory board (or module) in the QBB is listed. Boards are

numbered from 0 to 3. Each QBB can have up to four memory boards.

➌

Each memory board has two sets (arrays) of DIMMs installed. A set is

numbered 0 or 1. Each set consists of four DIMMs.

➍

In this example, all DIMMs have the same density (4 GB) and are in a 32-

way interleave. The first array on board 0 is board 0, set 0, and is

referred to as array 0; the second array on board 0 is board 0, set 1, and

is referred to as array 4, and so forth.

➎ The size, or density of the array.

➏ The starting address of the array.

➐

Identifies each QBB in the system.

➑

The total available memory in the QBB.

7.3 Setting SRM Environment Variables

You may need to set several SRM console environment variables and

built-in utilities to configure systems running the Tru64 UNIX or

OpenVMS operating systems.

Set environment variables at the P00>>> prompt.

•

To check the setting for a specific environment variable, enter the show

envar command, where the name of the environment variable is

substituted for envar.

•

To reset an environment variable, use the set envar command, where the

name of the environment variable is substituted for envar.

For more information on environment variables, see the AlphaServer

GS80/160/320 Firmware Reference Manual.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 180 181

Pas de commentaire

Compaq AlphaServer 160 Guide de l'utilisateur Page 129