Compaq ProLiant SL165s Spécifications télécharger pdf (Page 110)

Diagnostic tools and setup utilities 110

These diagnostics, which reside in the BIOS ROM, isolate the server-related logic failures and indicate

the board or component that you need to replace, as indicated by the error messages. Most server

hardware failures will be accurately isolated during POST. The number of tests displayed depends on

the configuration of the server.

During POST you can:

• Press F10 to access the Setup Utility.

POST error indicators

When POST detects a system failure, it displays a POST error message.

POST related troubleshooting

Perform the following procedures when POST fails to run, displays error messages.

If the POST failure is during a routine boot up, check the following:

• All external cables and power cables should be firmly plugged in.

• The power outlet to the server should be connected and works correctly.

• The server and monitor are both turned on. The bicolour status LED indicator on the front panel

must be lit up green.

• The monitor's contrast and brightness settings are correct.

• All internal cables are properly connected and all boards firmly seated.

• The processor is fully seated in its socket on the system board.

• The heat sink assembly is properly installed on top of the processor.

• All memory modules are properly installed.

• If you have installed a PCI accessory board, verify that the board is firmly seated and any

jumpers on the board are properly set. Refer to the documentation provided with the accessory

board.

• All internal cabling and connections are in their proper order.

• If you have changed the jumpers on the system board, verify that each is properly set.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 116 117

Pas de commentaire

Compaq ProLiant SL165s Spécifications Page 110