Compaq 4354R - StorageWorks Enclosure Storage Manuel de service télécharger pdf (Page 143)

Configuration Procedures 5–21

Configuration Options

Changing the CLI Prompt

To change the CLI prompt, enter a 1- to 16- character string as the new prompt, according

to the following syntax:

SET THIS_CONTROLLER PROMPT = “NEW PROMPT”

If you are configuring dual-redundant controllers, also change the CLI prompt on the

“other controller.” Use the following syntax:

SET OTHER_CONTROLLER PROMPT = “NEW PROMPT”

NOTE: It is suggested that the prompt name reflect some information about the controllers. For

example, if the subsystem is the third one in a lab, name the top controller prompt, LAB3A and

the bottom controller, LAB3B.

Mirroring cache

To specify mirrored cache, use the following syntax:

SET THIS MIRRORED_CACHE

Adding Disk Drives

If you add new disk drives to the subsystem, the disk drives must be added to the

controllers’ list of known devices:

■ To add one new disk drive to the list of known devices, use the following syntax:

ADD DISK DISKNNNNN P T L

■

To add several new disk drives to the list of known devices, enter the following

command:

RUN CONFIG

Adding a Disk Drive to the Spareset

The spareset is a collection of spare disk drives that are available to the controller should it

need to replace a failed member of a RAIDset or mirrorset.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 217 218

Pas de commentaire

Compaq 4354R - StorageWorks Enclosure Storage Manuel de service Page 143