Compaq Compaq Portable II Guide de dépannage télécharger pdf (Page 142)

NOTE: Terminating resistors are located in different positions on the drive

depending on the manufacturer.

To replace the fixed disk drive in the fixed disk drive expansion unit,

reverse steps 1 through 5.

Power Supply

To remove the power supply from the fixed disk drive expansion unit, complete

the following steps.

1. Complete the preparation procedures at the beginning of Section 8.30.

2. Remove the four screws securing the power supply assembly to the fixed

disk drive expansion unit chassis (Figure 8-111).

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 165 166

Pas de commentaire

Compaq Compaq Portable II Guide de dépannage Page 142