Compaq Compaq Portable II Guide de dépannage télécharger pdf (Page 75)

Chapter 8.7 System Board Cover

To remove the system board cover:

1. Complete the preparation procedure (see Section 8.2).

2. Remove the rear panel (see Section 8.4).

3. Remove the interface connector cover, if installed (see Section 8.5).

4. Remove the 32 bit memory/modem interface board, if installed (see

Section 8.8).

5. Remove the microprocessor cover (see Section 8.6).

6. Locate the system board cover shown in Figure 8-9.

7. Remove the screws that secure the system board cover to the system board

assembly and set them aside.

8. Lift the system board cover up and away from the computer and set it

aside (Figure 8-10).

To replace the system board cover, reverse steps 1 through 8.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 165 166

Pas de commentaire

Compaq Compaq Portable II Guide de dépannage Page 75