Compaq 380 Spécifications télécharger pdf (Page 53)

Removal and Replacement Procedures 2-41

Power Converter Module

To remove the power converter module:

1. Power down the server. See the “Powering Down the Server” section in this chapter.

2. Extend or remove the server from the rack. See the “Preparation Procedures” section in

this chapter.

3. Remove the access panel. See the “Access Panel” section in this chapter.

4. Remove all hot-plug fans in the front fan bracket. See the “Hot-Plug Fan” section in this

chapter.

5. Remove the front fan bracket. See the “Front Fan Bracket” section in this chapter.

6. Remove all hot-plug power supplies. See the “Hot-Plug Power Supply” section in this

chapter.

7. Disconnect all power cables:

a. Disconnect the system power cable from the system board .

b. Disconnect the power supply signal cable from the system board .

c. Disconnect the SCSI power cable from the SCSI backplane .

Figure 2-40. Disconnecting the power cables

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 120 121

Pas de commentaire

Compaq 380 Spécifications Page 53