Compaq 380 Spécifications télécharger pdf (Page 46)

2-34 Compaq ProLiant DL380 Generation 2 Server Maintenance and Service Guide

Expansion Board (Slot 1)

To remove an expansion board from slot 1:

1. Power down the server. See the “Powering Down the Server” section in this chapter.

2. Extend or remove the server from the rack. See the “Preparation Procedures” section in

this chapter.

3. Remove the access panel. See the “Access Panel” section in this chapter.

4. Remove the PCI riser cage. See the “PCI Riser Cage” section in this chapter.

5. Disconnect any cables connecting the expansion board to the PCI riser cage.

6. Remove the PCI shipping bracket, if installed. See the “PCI Shipping Bracket” section in

this chapter.

7. Remove the expansion slot thumbscrew .

8. Remove the expansion board from its slot .

Figure 2-33. Removing an expansion board from slot 1

CAUTION: Always install either an expansion board or an expansion slot cover. Operating the

server without an expansion board or slot cover results in improper airflow and cooling that can

lead to thermal damage.

Reverse steps 1 through 8 to replace the expansion board.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 120 121

Pas de commentaire

Compaq 380 Spécifications Page 46