Compaq Reliable Transaction Router Guide d'installation télécharger pdf (Page 43)

Full Installation on Compaq Tru64 UNIX

5.1 Preparing for RTR Installation on Compaq Tru64 UNIX

5.1.4.2 Checking Hardware Requirements

To install RTR, you need the following hardware:

• Software distribution device (if installing from media)

Locate the CD-ROM drive for the CD-ROM software distribution media.

The CD booklet or the documentation for the CD-ROM drive you are using

explains how to load the CD-ROM media.

• Terminal

You can use a hardcopy or video terminal or a workstation to communicate

with the operating system and respond to prompts from the installation

procedure.

See the RTR Software Product Description (SPD) for additional hardware

requirements.

5.1.4.3 Checking Software Requirements

RTR requires that the following Compaq Tru64 UNIX software subset be

loaded on the system where you install RTR:

• OSFBASE—the Base System subset

One of the following is required:

• DECnet

• Compaq DECnet-Plus for Tru64 UNIX V4.0

• TCP/IP

The following Compaq Tru64 UNIX software subsets are optional on the system

where you install RTR:

• OSFCLINET200—Basic Networking Services (TCP/IP) subset

• DNABASE110—DECnet/OSI Base Components subset, together with

• DNANETMAN110—DECnet/OSI Network Management subset

To check whether these subsets are loaded, follow these steps:

1. Log in to the system where you will install RTR.

2. Enter the following command:

# setld -i | egrep ’OSFBASE|DNA’

If your path is not set as

/usr/sbin/

, you must enter the full path of the

command. For example:

% /usr/sbin/setld -i | egrep ’OSFBASE|DNA’

Full Installation on Compaq Tru64 UNIX 5–3

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 53 54

Pas de commentaire

Compaq Reliable Transaction Router Guide d'installation Page 43