Compaq AlphaServer ES40 Spécifications télécharger pdf (Page 131)

Using the Remote Management Console 4-29

Figure 4–4 RMC Jumpers (Default Positions)

PK0211

1 2 3

1 2

J24

J25

J26

J31

Plug a power cord into one power supply, and then wait until the control

panel displays the message “System is down.”

Unplug the power cord. Wait until the +5V Aux LED on the power supply

goes off before proceeding.

Install jumper J25 over pins 2 and 3.

10.

Reinstall CPU1, the card cage cover and fan cover and the enclosure panels.

11.

Plug the power cord into each of the power supplies.

NOTE: After the RMC has been reset to defaults, perform the setup procedures

to enable remote dial-in and call-out alerts. See Section 4.6.5.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 239 240

Pas de commentaire

Compaq AlphaServer ES40 Spécifications Page 131