Compaq dc7800 - Convertible Minitower PC Guide de l'utilisateur télécharger pdf (Page 21)

Removing Bezel Blanks

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as diskettes or compact discs, from the computer.

3. Turn off the computer properly through the operating system, then turn off any external devices.

4. Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as

long as the system is plugged into an active AC outlet. You must disconnect the power cord to

avoid damage to the internal components of the computer.

5. Remove the computer access panel.

6. Remove the front bezel.

7. Gently pull the subpanel, with the bezel blanks secured in it, away from the front bezel, then remove

the desired bezel blank.

CAUTION: Hold the subpanel straight when you pull it away from the front bezel. Pulling the subpanel

away at an angle could damage the pins that align it within the front bezel.

Figure 2-6 Removing Bezel Blanks from the Subpanel (Desktop Shown)

NOTE: When replacing the subpanel, ensure that the aligning pins and any remaining bezel blanks

are in their proper orientation. The logo on the subpanel should be located at the bottom of the subpanel

when properly oriented.

ENWW Removing Bezel Blanks 15

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 61 62

Pas de commentaire

Compaq dc7800 - Convertible Minitower PC Guide de l'utilisateur Page 21