C-2
Switch Settings
For use withPentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Sam Ogden Project: Compaq ProLiant 6500 Setup and Installation Guide Comments: 328196-002 (February 1999)
File Name: K-APPC.DOC Last Saved On: 3/16/99 10:27 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Core Frequency Switch
(SW2 and SW3)
For location of the Core Frequency Switch (SW2 and SW3), see the hood label
under the top access panel of the server. Table C-2 describes the Core
Frequency Switch (SW2 and SW3) positions for the processors:
Table C-2
Core Frequency Switch (SW2 and SW3)
Switch Position Core Frequency
S1 S2 S3 S4 Processor
ON ON OFF ON 400 MHz
OFF ON OFF ON 450 MHz
ON ON OFF OFF 500 MHz
OFF ON OFF OFF 550 MHz
NOTE: SW2 applies to processors 1 and 2; SW3 applies to processors 3
and 4. The OFF position indicates a switch is open.
NOTE: Compaq makes no representation or warranty that processors that
operate at any of the speeds shown will be available at any time.
Commentaires sur ces manuels