Compaq ProLiant 6500 Guide d'installation Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 196
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
1-5
Compaq ProLiant 6500 Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Sam Ogden Project: Compaq ProLiant 6500 Setup and Installation Guide Comments: 328196-002 (February 1999)
File Name: B-CH01.DOC Last Saved On: 3/16/99 10:58 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
These utilities are provided on the Compaq Support Software for Microsoft
Windows NT 4.0 diskettes (NTSSD). For more detailed information, see the
NTREADME.HLP file on Diskette 1. Future operating sytem support is
planned for later release.
System Power Supplies Management:
Guidelines
CAUTION: Unless operating at 220V, it may be necessary to make
tradeoffs with respect to which options can be added and
powered with the installed power supplies while still remaining
redundant.
Use the following guidelines when evaluating these tradeoffs.
NOTE: The following guidelines are general. Use the Power Supply Viewer
Utility and option documentation to obtain the most accurate power capacity
and assessment of power margin.
Comparing processor and hard drive power: two processors draw as
much current as five to six hard drives.
Comparing memory and 3.3V-powered PCI Expansion Board power:
each additional 512 MB draws approximately as much current as one to
two PCI boards.
Comparing hard drive and 5V-powered PCI Expansion Board Power: one
PCI card draws as much current as two to five hard drives.
In general, PCI array controllers draw more current than PCI NICs.
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 195 196

Commentaires sur ces manuels

Pas de commentaire