Compaq dx2818 - Microtower PC Spécifications télécharger pdf (Page 125)

Power Switch Assembly

1. Prepare the computer for disassembly (Preparation for Disassembly on page 83).

2. Remove the access panel (

Access Panel on page 84).

3. Remove the front bezel (

Front Bezel on page 85).

4. Rotate the drive cage to its upright position.

5. Disconnect the power switch wires from the black system board connector labeled F_PANEL.

6. Rotate the drive cage back down.

7. Press the tab on the bottom of the assembly to disengage it from the chassis (1).

8. Slide the assembly downward to disengage the tab (2) on the top of assembly from the chassis.

9. If necessary, rotate the drive cage back up to gain access to the wires.

10. Pull the assembly out through front of unit (3) while threading the wires through the hole in the

chassis.

To install the power switch assembly, reverse the removal procedure.

Power Switch Assembly 115

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 161 162

Pas de commentaire

Compaq dx2818 - Microtower PC Spécifications Page 125