Compaq Compaq Portable II Spécifications télécharger pdf (Page 57)

up from the system chassis and lifting it away from the computer.

To replace the board slots access plate, reverse Steps 1 through 3.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

CAUTION

Ensure that the retainers on the bottom side of the board slots access plate

fit securely onto each board installed in your computer. If you changed to a

board of a different height, rotate the retainers to match the height of the

board. If the retainers are not rotated, serious internal damage may result!

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

Chapter 7.5 High Voltage Access Plate Removal and Replacement

To remove and replace the high voltage access plate:

1. Complete the Access Cover Removal Procedure (see Section 7.3).

2. Loosen (DO NOT REMOVE) the six screws and the two 1/4 inch nuts securing

the high voltage access plate (Figure 7.5-1). Slide the metal cover

toward the rear of the computer and lift it off.

To replace the high voltage access plate, reverse Steps 1 and 2.

Cha

ter 7.6 Mass Stora

e Device Access Plate Removal and Re

lacement

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 128 129

Pas de commentaire

Compaq Compaq Portable II Spécifications Page 57