Compaq HSZ80 Guide d'installation télécharger pdf (Page 14)

COMPAQ StorageWorks Upgrading From an HSZ70 to an HSG80 Array Controller

Page 14 EK-HSG80-UP. B01

For Fibre Channel switch environments the topology using:

HSG80> SET THIS_CONTROLLER PORT_1_TOPOLOGY=FABRIC

HSG80> SET THIS_CONTROLLER PORT_2_TOPOLOGY=FABRIC

Using information from the Installation Reference Guide for your server’s operating system,

set the Arbitrated Loop Physical Address (ALPA) NN of the controller ports using:

HSG80> SET THIS_CONTROLLER PORT_1_AL_PA=NN

HSG80> SET THIS_CONTROLLER PORT_2_AL_PA= NN

Set the SCSI version using:

HSG80> SET THIS_CONTROLLER SCSI_VERSION=SCSI-2

Restart this controller for the new settings to take effect.

HSG80> RESTART THIS_CONTROLLER

If the configuration being upgraded is a single controller proceed to Section 11.0, Creating

the HSG80 Logical Units. If the configuration included dual-redundant controllers, install the

second controller as outlined in the next section.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Pas de commentaire

Compaq HSZ80 Guide d'installation Page 14