Compaq ProLiant Storage System U1 Guide de l'utilisateur télécharger pdf (Page 40)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2-12 Installation of ProLiant Storage System /U

Compaq ProLiant Storage System /U User Guide

Cabling

Cabling requirements vary depending on the system configuration. See your

specific system configuration below for cabling instructions.

Rack-Mountable Systems

To ensure that the cabling in the back of a rack system does not interfere with

system operation or maintenance, follow these suggestions for cable

management on those systems. See Figure 2-10.

This configuration will allow removal of either hot-pluggable power supply in

redundant power supply systems without disturbing system operation. With the

cables out of the way, status indicators will be easily visible.

■ All cables, including SCSI and power, for each storage system should be

bundled together along the plane of the top of the system. Use one or

more cable ties to hold the cables together securely at the back of

the unit.

■ All cables should run through the cable channel on the left side of

the rack.

■ Tie the cable bundle securely to the cable channel to relieve the stress on

the connectors at the back of the storage system.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 109 110

Pas de commentaire

Compaq ProLiant Storage System U1 Guide de l'utilisateur Page 40