Compaq ProLiant Storage System U1 Guide de l'utilisateur télécharger pdf (Page 46)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2-18 Installation of ProLiant Storage System /U

Compaq ProLiant Storage System /U User Guide

5. Select View or edit details.

6. Locate the SCSI controllers and verify that the installed drives

are displayed.

7. If you are using a Compaq SMART SCSI Array Controller or a

SMART-2 Array Controller Family Product, you should verify the

logical drive configuration, paying special attention to the selected fault

tolerance method. For this configuration information, refer to:

❏ the README files for Release Notes for Compaq supplied

operating systems

❏ your software documentation for other operating systems

❏ the documentation supplied with your Compaq array controller

8. Select Save the configuration and exit.

The utility will configure your system to recognize any new controllers and

devices. Reboot your system normally to begin using the added disk space on

the storage system.

From CD

Use these instructions to run the Compaq System Configuration Utility if your

server:

■ has not had this utility previously installed on the boot drive, and

■ has a bootable CD-ROM drive

To run the System Configuration Utility directly from the SmartStart and

Support Software CD included with the ProLiant Storage System /U:

1. Be sure all new drives are in place and the storage system is turned ON.

2. Boot the server from the CD.

3. Select Run System Configuration Utility.

4. Select Review hardware settings.

5. Select View or edit details.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 109 110

Pas de commentaire

Compaq ProLiant Storage System U1 Guide de l'utilisateur Page 46