Compaq Mega-Post Guide de l'utilisateur télécharger pdf (Page 18)

MegaRAID IDE Linux Installation User's Guide 10

Step 3 Installing RedHat, Continued

Steps Description

At the prompt type

Bash# runpinst

You will then be prompted to enter the AMIPINST floppy. Insert this floppy and hit the <enter> key.

When the prompt returns and the floppy drive light turns off, press <CTRL><ALT><F7> to return to

the installation window.

Note: Do not create a boot floppy. It is not supported by MegaRAID IDE at this time.

Click Next, then Exit and Reboot. Remove the floppy and the RedHat CD while your system is

rebooting. When your system boots-up, log in as root.

Step 4 Installing the Monitoring Software

The final step is to install the two RedHat Package Manager (RPM) files. Thy are as

follows:

• Hyperconf-1.0-2.i386.rpm

• Kernel-2.2.16-3.i386.rpm.

Go to the directory were these files are located and install them using the following

command:

# rpm –I Kernel-2.2.16-3.i386.rpm.

# rpm –I Hyperconf-1.0-2.i386.rpm

Hyperconf Hyperconf is the monitoring software that is use to keep track of your RAID array. It is

installed when you install hyperconf-1.0.2.rpm using the RedHat Package Manager

(RPM). This software allows you to monitor the status of you RAID array. It will also

allow you to set a number of variables that will determine the behavior of you RAID array.

Installing Hyperconf Hyperconf is simple to install. Go to the directory where the RPM file

HYPERCONF-1.0.2.RPM is located. At the command prompt type the following:

rpm –I hyperconf-1.0.2.rpm

This will install the software. The following files are installed on your system:

File Location Description

HYPERCONF8.RZ USR/MAN8/ Man Page for Hyperconf

README USR/DOC/HYPERCONF-1.0.2/ README for Hyperconf

HYPERCONF /USR/SBIN/ Executable for Hyperconf

SPY /RC.D/INIT.D/ Batch file that loads SPYD (Soft link is

created to RC3.D to start the service in

run level 3)

SPYD /USR/SBIN/ Damon for Hyperconf

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Pas de commentaire

Compaq Mega-Post Guide de l'utilisateur Page 18