Compaq StorageWorks 6000 - Virtual Library System Guide de l'utilisateur télécharger pdf (Page 263)

CAUTION:

Electrostatic discharge can damage electronic components. Properly ground yourself before beginning

any installation procedure.

1. Power off the node. See Powering Off the System.

2. Extend the node from the rack. See Extending the Node from the Rack.

3. Lift up on the hood latch handle which slides the panel toward the rear of the unit.

4. Lift up the panel to remove it.

Removing the VLS6600 Node Access Panel

WARNING!

Pressing the Power on/Standby button sets the node to the standby position, which removes power

from most areas of the node. However, portions of the power supply and some internal circuitry

remain active until the AC power cord is removed.

WARNING!

To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool

before touching them.

CAUTION:

Do not operate the node for long periods without the access panel. Operating the node without the

access panel results in improper airflow and improper cooling that can lead to thermal damage.

CAUTION:

Electrostatic discharge can damage electronic components. Properly ground yourself before beginning

any installation procedure.

1. Power off the node. See Powering Off the System.

2. Extend the node from the rack. See Extending the VLS6600 Node from the Rack.

3. Use the T-15 Torx screwdriver attached to the rear of the node to loosen the security screw on

the hood latch.

4. Lift up on the hood latch handle and remove the access panel.

HP StorageWorks 6000–series Virtual Library System User Guide 263

1 2 ... 258 259 260 261 262 263 264 265 266 267 268 ... 357 358

Pas de commentaire

Compaq StorageWorks 6000 - Virtual Library System Guide de l'utilisateur Page 263