Compaq StorageWorks 6000 - Virtual Library System Guide de l'utilisateur télécharger pdf (Page 296)

100

101

1. Lift the release lever and pull the fan module out of the enclosure.

Figure 109 Removing a disk array fan module

2. Slide the replacement fan module into the disk array until it is firmly seated in the disk array.

3. Confirm that the fan module starts operating immediately and that the status LED is illuminated

green.

Power Supply

CAUTION:

Before removing a power supply from the disk array, be sure that a replacement power supply is

immediately available. Removing a power supply causes a significant change in the airflow within

the disk array, and the disk array could overheat if a replacement power supply is not installed within

a relatively short time.

1. Disconnect the AC power cord from the defective power supply unit.

2. Squeeze the handle and the release lever together and pull the defective power supply unit out

of the disk array by the handle.

Figure 110 Removing a disk array power supply

3. Insert the replacement power supply unit into the empty bay until it is firmly seated in the disk

array.

4. Connect the AC power cord.

5. Confirm that the status LED on the replacement power supply is illuminated green.

Component Replacement296

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 357 358

Commentaires sur ces manuels

Pas de commentaire

Compaq StorageWorks 6000 - Virtual Library System Guide de l'utilisateur Page 296

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Compaq StorageWorks 6000 - Virtual Library System