Compaq StorageWorks 6000 - Virtual Library System Guide de l'utilisateur télécharger pdf (Page 265)

Installing the VLS6100, VLS6200, or VLS6500 Node Access Panel

1. Set the access panel on top of the node about a ¾ inch (0.2 inch for the VLS6200) from the

opening with the hood latch open.

2. Engage the anchoring pin with the corresponding hole in the latch.

3. Push down on the hood latch.

4. Slide the access panel into the closed position.

Installing the VLS6600 Node Access Panel

1. Set the access panel on top of the node about a 1/2 inch from the opening with the hood latch

open.

2. Push down on the hood latch.

3. Slide the access panel into the closed position.

4. Use the T-15 Torx screwdriver attached to the rear of the node to tighten the security screw on

the hood latch.

Installing the VLS6800 Node Access Panel

1. Place the access panel on top of the node with the latch open. Allow the panel to extend past

the rear of the node approximately 1.25 cm (0.5 inches).

2. Push down on the latch.

3. Slide the access panel into the closed position.

VLS6100 and VLS6500 Node Component Replacement

SATA Hard Drive

CAUTION:

To prevent improper cooling and thermal damage, do not operate the node unless all bays are

populated with either a component or a blank.

NOTE:

SATA hard drive LED functionality and hot-plug capability are not currently supported.

1. Power off the node. See Powering Off the System.

2. Press the drive latch release button (1).

HP StorageWorks 6000–series Virtual Library System User Guide 265

1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 357 358

Pas de commentaire

Compaq StorageWorks 6000 - Virtual Library System Guide de l'utilisateur Page 265