Compaq Armada 1120T Guide de dépannage télécharger pdf (Page 50)

The display ground cable connects to the display shield on one end, and

the other end clips to the flex ground bracket located above the serial

port between the system board and system chassis.

The display inverter board is aligned to the right of the display

enclosure with pins. One end connects to the display cable; the other end

connects to the backlight cable of the LCD panel.

To replace the display assembly, the assembly must be removed from the

system unit module. This is done by removing the keyboard assembly,

disconnecting the display cable and display ground cable from the system

unit module, removing the tilt feet and handle brackets, removing the rear

clutch screws, and lifting off the display assembly.

To service display components, do not remove the display assembly from the

system unit module (unless replacement of the display enclosure or clutch

is required). Access display components (inverter board or latches) by

removing the bezel secured with four screws on the front of the display.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 197 198

Pas de commentaire

Compaq Armada 1120T Guide de dépannage Page 50