Compaq HSG80 - StorageWorks RAID Array Controller Spécifications Page 131

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 296
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 130
Troubleshooting Resources 4–25
Last Failure Reporting
Last failures are automatically displayed on the maintenance terminal (unless disabled via
the FMU) using %LFL formatting. The example below details an occurrence of a Last
Failure report:
In addition, Last Failures are reported to the host error log using Template 01, following a
reboot of the controller. See Table 5–2 for a more detailed explanation of this template.
Events That Allow Controller Operation to Continue
Events that do not cause controller operation to terminate are displayed in one of two
ways:
Spontaneous event log
CLI event reporting
■●●●●●●
3F DAEMON diagnostic failed hard in
non-fault tolerant mode.
DAEMON diagnostic detected critical
hardware component failure; controller
can no longer operate.
Verify that cache module is present. If the
error persists, replace controller.
Table 4–5 Solid OCP Patterns (Sheet 5 of 5)
Pattern OCP
Code
Error Repair Action
%LFL--HSG> --13-JAN-1999 04:39:45 (time not set)-- Last Failure
Code: 20090010
Power On Time: 0.Years, 14.Days, 19.Hours, 58.Minutes, 42.Seconds
Controller Model: HSG80
Serial Number: AA12345678 Hardware Version: 0000(00)
Software Version: V085F(55)
Informational Report
Instance Code: 0102030A
Last Failure Code: 20090010 (No Last Failure Parameters)
Additional information is available in Last Failure Entry: 1.
Vue de la page 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 295 296

Commentaires sur ces manuels

Pas de commentaire